Xiaomi switch - MQTT - how to set up in Loxone Config?

[Gast]

Hello
I'm looking for help to setup Loxone config for my Xiaomi zigbee switch and Cube
The Zigbee2MQTT and MQTT Gateway works has expected and I'm getting MQTT messages from/to zigbee devices.

I hit a roadblock on how to set up the Virtual input for Xiaomi switches. I'm converting the single, double messages converted to boolean. When I make a single click, the virtual input in the miniserver switches to "On" and stays on. I expect an impulse and not a permanent "on".
The VI is connected to a Push Switch block.

How do I get the VI to turn back to "off / 0" shortly after the MQTT "ON / 1" message turn the VI to ON?

thanks a lot!

[Clubsport]

In the MQTT Gateway, you have to set the checkmark for „Reset after Send“ …

[Gast]

apologies for not getting back earlier... my mqtt gateway/zigbee2mqtt set up got corrupted following a power outage and had to rebuild the whole thing.
thanks for the tip, it works flawlessly now!