Virtual Output not triggering Tasmota Smart Socket

[rob99]

I have a smart plug which has been flashed with Tasmota v9.4.0 and connects easily to my wifi network so I am able to send http commands to it.

However, although I can successfully send http commands through a browser to switch on/off, I can’t seem to get the same commands to work in Loxone through a Virtual Output.

I attach screenshots of my Loxone VO config in case I’m doing something obviously wrong.

Cheers

Rob

[deepinpowder]

Hy,

you need to replace the IP x.x.x.x will not work.
If you used the x to anonymise check the VO xml from the loxwiki : https://www.loxwiki.eu/display/LOX/E...Tasmota+Sonoff
Mine works with the VO without any problems.

Cheers

[Loxtom577]

There is no colon after http in the address. If this is also the case in the real address, then it cannot work

[rob99]

Hy,

you need to replace the IP x.x.x.x will not work.
If you used the x to anonymise check the VO xml from the loxwiki : https://www.loxwiki.eu/display/LOX/E...Tasmota+Sonoff
Mine works with the VO without any problems.

Cheers

As a security precaution, I only substituted x.x.x.x to remove the IP address from the screenprint before posting on a public forum.

[Thomas M.]

the IP is the local IP of your tasmota? security precaution? I can tell you the IP of my shelly 3em => 192.168.0.124
local IPs are not safety critical, you can't reach my shelly whatever you try

[rob99]

There is no colon after http in the address. If this is also the case in the real address, then it cannot work

Ohhh, well spotted!!

Schoolboy error from me...........added the colon and all working.

Thanks so much

Rob

[Christian Fenzl]

Just to point out, that local IP addresses are not secret and to blur them will make support difficult, but your network not more secure.

[rob99]

Thomas M.

Yep, understand about internal IP addresses, it's just a habit I've got into over the years for all IP addresses