Bosch-Junkers WP Compress 5800i in Loxone integrieren?

[Benny]

Hallo,

hat schon mal jemand eine Bosch WP Compress 5800i in Loxone integriert? Welcher Weg bietet sich hier am besten an?

Danke.

[BDP]

https://github.com/emsesp/EMS-ESP32

https://bbqkees-electronics.nl/?lang=de

https://bbqkees-electronics.nl/wiki/home-automations/loxone-configuration.html

I would try this. I integrated a few Junkers (Bosch) heaters. I think the Compress 5800 is supported as Well.

[Benny]

Thanks. So i dont need to buy extra hardware module from Junkers (Bosch), only about 100 Euros for EMS board? Is WiFi only working stable or better using LAN cable?

Is it possible to start warmwater heating with an external command via Miniserver (when there is enough sun power)?

[BDP]

Hallo,

You need to buy hardware from BBQkees.
It's not supported by Bosch. They try to decode all Bosch EMS messages and made software and hardware to make it available for home automation systems.
I think Bosch only offers a KNX based solution, but not sure if this still works for heatpumps. And the KNX solution is very expensive.
I would buy

https://bbqkees-electronics.nl/product/demnaechst-verfuegbar-gateway-e32-v2-ethernet-wifi-ausgabe-v2/?lang=de

When it becomes available again. I prefer cable but WiFi should work as well. You connect service jack from heatpump to gateway and lan cable/wifi
Normally it should be possible to change hot water temperature, but it depends on the device and regelung