Tweet
time(r) not correct - lights don't turn on fully.
Hi dear people of loxforum,
since a few days I'm experiencing something weird.
I have several "schedule" modules, so that between several hours the lights got dimmed automatically.
Example, from 7PM (19:00) until 7AM (07:00) this schedule gives an output of 1, which drives the MS input the light-controller. (I have a mood with numbering "1" which outputs the light to x%).
So when this window of time is not active, MS has a value of 0 and the Motion sensor should just activate (all, for example in our Kitchen we have 2 light zones, controlled by on light-controller) outputs depending on motion and Lux sensor.
Now the issue: since 2 or 3 days, the light doesn't go bright anymore. It remains in the mood set by this schedule.
When I look at configuration of the miniserver itself, NTP is enable and if I would change it to local time, that time displayed is correct with the actual current time...
Today I noticed that at 08.35 the lights went to "bright" (all on).
So the time looks like it is of by and odd number of 1 hour and 35 minutes.
In week-days the time is from 22.00 to 07.00
weekends: 22.00 to 08.00
holidays (don't know if that is setup somewhere), leave days, etc.. also: 22.00 to 08.00
So nowhere a time of 08.35 is configured.
=> These issues started out of nothing. I think I didn't change the config for a couple of months...
When I did a liveview, I saw that the schedule was not active (it was after 07.00) so I really don't know where to look.
Thanks in advance!
kind regards,
Jaip
since a few days I'm experiencing something weird.
I have several "schedule" modules, so that between several hours the lights got dimmed automatically.
Example, from 7PM (19:00) until 7AM (07:00) this schedule gives an output of 1, which drives the MS input the light-controller. (I have a mood with numbering "1" which outputs the light to x%).
So when this window of time is not active, MS has a value of 0 and the Motion sensor should just activate (all, for example in our Kitchen we have 2 light zones, controlled by on light-controller) outputs depending on motion and Lux sensor.
Now the issue: since 2 or 3 days, the light doesn't go bright anymore. It remains in the mood set by this schedule.
When I look at configuration of the miniserver itself, NTP is enable and if I would change it to local time, that time displayed is correct with the actual current time...
Today I noticed that at 08.35 the lights went to "bright" (all on).
So the time looks like it is of by and odd number of 1 hour and 35 minutes.
In week-days the time is from 22.00 to 07.00
weekends: 22.00 to 08.00
holidays (don't know if that is setup somewhere), leave days, etc.. also: 22.00 to 08.00
So nowhere a time of 08.35 is configured.
=> These issues started out of nothing. I think I didn't change the config for a couple of months...
When I did a liveview, I saw that the schedule was not active (it was after 07.00) so I really don't know where to look.
Thanks in advance!
kind regards,
Jaip