Tweet
I take it any normal surface door contact will work with a miniserver? ;-)
-
-
If you ask for "any", it's difficult to answer this question, because there might be a door contact that will not work with the MS. There is a section in the Loxwiki about this topic: https://www.loxwiki.eu/display/LOX/Glasbruchsensor (hope that Google translator is good enough to understand the content) The one described there IS compatible.Miniserver v14.5.12.7, 2x Ext., 2x Relay Ext., 2x Dimmer Ext., DMX Ext., 1-Wire Ext., Gira KNX Tastsensor 3 Komfort, Gira KNX Präsenzmelder, Fenster- und Türkontakte, Loxone Regen- und Windsensor, Gira Dual Q Rauchmelder vernetzt, 1x Relais-Modul
Loxberry: SmartMeter, MS Backup, CamConnect, Weather4Lox
Lüftung: Helios KWL EC 370W ET mit Modbus TCP - via Pico-C
Heizung: Stiebel Eltron WPF 5 cool (Sole-Wasser WP) mit ISG, FB-Heizung mit 18 Kreisen, Erdsonde - via modbus/TCP
Node-RED: IKEA Tradfri -
Jan W.
Thanks for the reply. I was meaning the likes of the window and door contact https://shop.loxone.com/enuk/window-contact.html type of sensors.
But i've noticed there is a section on that Loxwiki so ill have a look through those.
Thanks again.Kommentar
-
The one in your link is a simple reed contact. There might be cheaper ones available in the Internet. Almost all reed contacts work the same way: if a magnet is put near the reed contact, the loop is closed. The connections is the same as described for the contact in the Loxone shop. I thought you were looking for a window sensor to detect breakage of the glass.
Personally I prefer the reed contacts that are installed inside the frame and not on top / side of the frame, because they are invisible. Depending on the type of the window, there might be a rail inside that slides when you turn the lever. These contacts need to match the vendor of the window. Here is a good article about those: https://wolf-u.li/5854/auswahl-und-e...rn-und-tueren/
-
Kommentar